My Ride: Gino's Husqvarna TC 250

Posted by BFD Marketing on

My Ride: Gino's Husqvarna TC 250

Take a closer look at my Husqvarna TC 250! The bike is pretty close to stock with a just a few changes to make it just right for me.

My Ride: Gino's Husqvarna TC 250

My Ride: Gino's Husqvarna TC 250

We are rocking an all-new decal kit by Greg at M7 Designs. Look for all the team bikes this year with this kit.

My Ride: Gino's Husqvarna TC 250

The TC 250 comes stock with the infamous Mikuni 38mm carburetor. We have a Husqvarna jet kit installed with 2018 settings:

Pilot 40

Needle 43-73 Clip 3

Main 440

This is the recommended setting at 2500-5000 feet at 6-15 degrees but I ride this all summer and just play with the air screw.

My Ride: Gino's Husqvarna TC 250

My Ride: Gino's Husqvarna TC 250

We have the FMF Factory Fatty installed with a Powerparts Powercore 2.1 Silencer. This combo gives the bike a lot more useable throughout the whole range and doesn't let it fall off the top like the stock pipe.

My Ride: Gino's Husqvarna TC 250

My Ride: Gino's Husqvarna TC 250

I run everything stock as far as handlebar setup except for the upper triple clamp. It is the one off of the FE models with no rubber bushings.

My Ride: Gino's Husqvarna TC 250

The stock shock and WP AER forks are taken care of by Ken at TNT Suspension.

My Ride: Gino's Husqvarna TC 250

Other parts include a Seat Concepts Super Grip seat covers, Dirt Tricks Ironman front and rear sprockets, a P3 skid plate, and DT1 air filters.

My Ride: Gino's Husqvarna TC 250

Thanks for checking out this months edition of My Ride! Look for more of these coming soon!


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.